do you need to replace kindle fire hd batteries

#Do you need to replace kindle fire hd batteries software#

I almost had a fire hazard because I configured one of the non-explosive shield tablet with a NFC charger and it expanded and I didn't realize it and things could have gone very wrong.

The personal recommendation: even if the battery is not an Explosive One(TM), remove it. So that's the bad news piece of information. Even when plugged with the USB cable, a lot of models will decide to not boot up.

The bad news: tablets don't like to be without battery. we decided to address the issue and have two of them as static tablets in the living and the kitchen. So we ended up with a total of 4 tablets, two of them had a dubiously dangerous battery.

#Do you need to replace kindle fire hd batteries software#

And in my country, the recall was done in a non-recall way: they sent you new ones and had a software killswitch on the old ones. you know, the ones that got recalled because of battery issues. You can still check the email manually when you open the email app.Some background: I and my SO had Shield tablets. If you don’t need your inbox to be checked so often then you can disable this feature. Your email app will check your inbox every 15 minutes or so, and every time it checks it will spend some battery power.

Swipe the slider to adjust the brightness.

Open the notification bar by swiping down from the top of the screen.

This will also prevent you from getting eyestrain. It may lengthen battery life by several hours. This is especially useful in low-light situations. Turn the Brightness DownĮven if you turn down the brightness to its lowest setting, the screen will still be easily viewable under most conditions. Now that you have fixed or replaced your battery, you can use some or all of these tips to improve the battery life of your device so you don’t have to charge it as often.

Lift the battery out of the device with your finger or the plastic opening tool.

Detach the plastic piece that connects the wires to the motherboard using the plastic opening tool.

Unscrew the T5 Torx screw using the other one.

Locate all four of the 3mm screws and unscrew them using the Phillips screwdriver.

You could also use your fingers or some other tool that fits, but it can be very difficult. If you don’t have a T5 Torx key, your neighbor might have a set or you may have to go down to a hardware store (any of them). The 2mm T5 Torx screw is located next to the antenna clip on the motherboard. You will need a Phillips #00 screwdriver and a T5 Torx key here.

Lift and pull up the power connector cable that surrounds the battery.

Find a gold-tipped black wire that goes along the battery.

Peel off the copper tape carefully, that’s if it’s still attached to your device.

Go around the device lifting the lid to release the clips securing the device to the lid.

Lift the lid until you hear a popping sound.

Insert the plastic opening tool (which should come with your replacement battery kit) into the lower right corner of your Kindle Fire.

Place your Kindle on a surface with the screen down.

Make sure that you power off your device before you begin.